Alltest JusChek SARS-CoV-2 and influenza A/B antigen test 1 pc

Alltest JusChek SARS-CoV-2 and influenza A/B antigen test is performed in case of acute respiratory tract infection , and is suitable if you suspect that you have contracted Covid-19 or influenza . This one-time test is used to quickly detect the presence of antigens of influenza types A, B and SARS-CoV-2 at the same time . The kit is intended for home self-testing from a nasal swab sample . Test evaluation in 10 minutes.

Main features

• rapid detection antigens of influenza type A/B + SARS-CoV-2
• for testing samples from the front of the nose
• suitable for lay people to self-test
• test result in 10 minutes

Preparation before sample collection

• Read all instructions carefully.
• Prepare a flat surface, such as a table. Make sure it is empty, clean and dry.
• Remove all jewelry from your hands.
• Wash your hands thoroughly, using soap and warm water or hand sanitizer. Dry your hands with clean disposable paper towels.

Sampling and testing

• Remove the cap from the extraction buffer tube and place it in the holder on the box.
• Remove the sterile tampon from the bag. Do not touch its soft end!
• Gently insert the swab end of the nasal swab into the left nostril (about 2 cm for an adult).
• Wipe the inner part of the nostril 5-10 times in a circular motion.
• It can be uncomfortable. Do not insert the tampon deeper if you feel strong resistance or pain.
• Nasal swab sampling is not recommended if the nasal mucosa is damaged or bleeding.
• Move the nasal swab to the other nostril and repeat the previous step in the same way. Make sure that a sufficient sample has been taken.
• Insert the nasal swab into the extraction buffer tube and swirl for 10-15 seconds to mix the contents well. At the same time push the tip of the nasal swab to the bottom and side of the tube.
• Press the swab against the wall of the tube to release as much liquid as possible from the swab and remove it.
• Put the tampon in a plastic bag. Place the dropper cap firmly on the tube and place it back in the holder on the box.
• Remove the test cartridge from the sealed bag and place it on a flat surface. The test should be performed as soon as possible, but no later than one hour after opening the bag.
• Turn the tube with the extracted sample upside down and add 3 drops to each well of the test cassette (S).
• Start timing. Do not move the test cartridge during the test.
• Read the test result in 10 minutes, do not read the results after 20 minutes.

Evaluate the result according to the package leaflet

• Positive result: Contact your doctor / general practitioner or local health facility immediately for a confirmatory PCR test. Follow local guidelines for self-isolation. Positive results do not exclude bacterial infection or co-infection with other viruses.
• Negative result: A negative result does not exclude the possibility of infection with the coronavirus or influenza type A/B. Continue to follow all applicable rules regarding contact with others and all protective measures. If you suspect the disease of COVID-19 or influenza, repeat the test after 1-2 days, because the coronavirus / influenza virus cannot be accurately detected in all stages of infection. If you have symptoms of COVID-19 or the flu, contact your doctor.

Package contents

• test cartridge
• extraction buffer
• sterile swab
• leaflet

• For in vitro (in test tube) diagnostic use only.
• For single use only, do not reuse. Do not use after the expiration date. Do not use if the package is damaged or opened.
• Children and the elderly take the test under the supervision of a person over the age of 18.
• Do not eat, drink or smoke in the area where samples or kits are handled.
• After completing the test, place all components in a plastic bag and seal tightly, then dispose of everything in accordance with local regulations.
• Do not drink the buffer in the kit. Handle buffer with care and avoid contact with skin or eyes, in case of contact, rinse immediately with plenty of running water.

MEDICAL DEVICE, READ INSTRUCTIONS FOR USE AND SAFE USE INFORMATION CAREFULLY. ZP class + RZPRO notification no.: IVD 1113680