Almirall Tannosynt liquid bath concentrate 100 g

Tannosynt liquid is a tannin preparation with anti-inflammatory and antipruritic effects.

Tannosynt liquid is an aqueous concentrate for use in the form of poultices, washes and baths for inflammatory, weeping and itchy skin diseases in the acute stage.
It contains a special water-soluble tanning agent, which has a soothing effect on inflammatory skin changes due to its astringent, tanning, scab-forming and vaso-sealing effects.

Excessive sweat secretion is slowed down. The treatment of fungal infections is supported by removing the breeding ground from the germs. In addition, Tannosynt liquid has antipruritic properties.

Tannosynt liquid is used for

• inflammatory, weeping and itchy skin diseases, e.g. diaper rash (inflammation of the skin caused by damp diapers);
• intertrigo (soreness in body folds);
• first-degree burns (reddening of the skin without blistering);
• itching – especially in the genito-anal area;
• excessive sweat secretion;
• as well as to support the local treatment of inflammatory fungal diseases.

Contraindications

Do not use Tannosynt liquid,

• if you are allergic to the synthetic tanning agent or any of the other ingredients of this medicine (listed in section 6).
• on the eye.

In the case of severe cardiac and circulatory disorders, high blood pressure, febrile illnesses or tuberculosis, no full baths - i.e. none with the addition of Tannosynt liquid - may be taken.

In the case of major skin injuries and acute unclear skin diseases, use Tannosynt liquid only after consulting a doctor.

Interactions

Other medicines and Tannosynt liquid - bath concentrate Tell your doctor or pharmacist if you are taking, have recently taken or might take any other medicines
.

Since synthetic tanning agent is not compatible with many other substances, no other additives should be added to baths and poultices with Tannosynt liquid.

Pregnancy and breastfeeding
Ask your doctor or pharmacist for advice before taking or taking any medicines.

There are no objections to the use of Tannosynt liquid during pregnancy and breastfeeding, as the active ingredient is not absorbed into the body through the skin.

Application

Always use this medicine exactly as described in this leaflet or as your doctor or pharmacist has told you. Check with your doctor or pharmacist if you are not sure.

For use on the skin. Do not use undiluted.

The dosages and instructions for use apply to infants, young children, children and adults.
The recommended dose is:Tannosynt liquid is used diluted with water (1:1000 to 1:
5000) in the form of poultices, washes or baths.

Unless otherwise prescribed by the doctor, poultices and ablutions are generally used several times a day, sitting, partial and full baths initially once a day, later two to three times a week.

The screw cap of the bottle is equipped with a measuring scale on the inside and is used for the correct dosage.
Tannosynt liquid dissolves in lukewarm and warm water without difficulty.

Partial bath – sitz bath – poultices – washes
5 l of water + 5 ml of Tannosynt (= 1/3 measuring cup) correspond to a dilution of 1:1000.

Children's bath
25 l water + 5 ml Tannosynt (= 1/3 measuring cup) correspond to a dilution of 1:5000.

Full bath
150 l water + 30 ml Tannosynt (= 2 measuring cups) correspond to a dilution of 1:5000.

The recommended duration of the bath is 10 – 15 minutes.
The bath temperature should be between 32 and 35° C.

Side effects

Like all medicines, this medicine can cause side effects, although not everybody gets them.
The frequency of adverse reactions is based on the following categories:Very common: more than 1 user in 10 Common: 1 to 10 users in 100 Uncommon: 1 to 10 users in 1,000 Rare: 1 to 10 users in 10,000
Very rare: less than 1 user in 10,000

Not known:
frequency cannot be estimated from the available data

When using Tannosynt liquid, mild skin irritation such as burning, redness and itching may occur very rarely. The active ingredient or excipients of Tannosynt liquid can very rarely lead to a hypersensitivity reaction of the skin (contact dermatitis).

If side effects occur, Tannosynt should be discontinued in liquid form and a doctor should be consulted.

Composition

The active ingredient is: phenol-methanal-urea polycondensate, sulfonated, sodium salt (synthetic tannin)
100 g of liquid bath additive contains 40.0 g of phenol-methanal-urea polycondensate, sulfonated, sodium salt (synthetic tannin).

The other ingredients are: purified water, sodium lauryl ether sulfate, sodium sulfate.