MiraTes Syphilis Test 1 pc

Every unprotected sexual intercourse today is associated with the risk of infection with one of the sexually transmitted diseases. If you have sores on or around your vagina, penis and mouth, this may indicate a bacterial infection that causes syphilis. This test will allow you to quickly and reliably determine if you have been infected with syphilis.

When a person is infected with syphilis, his body makes antibodies against them. A syphilis test can detect the presence of these antibodies in the blood. Once a blood sample is placed in the test cassette, one or two colored strips appear in the test. Account must also be taken of the fact that it may take some time after infection for the body to produce enough antibodies to be detected. A negative result can also occur after recent contact with bacteria and does not rule out infection.

Dosage:

How to use:

• Open the package labeled IMP Syphilis Test and pull out the test cassette. Place the device on a clean, flat surface.
• Before taking a blood sample, wash your hands with soap and water. Rinse well and dry thoroughly. Sit back and try to relax for 5 minutes, rubbing your hands together so that they are warm. The finger should not be cold and must be free of hardening.
• Take the lancet, turn the colored peg and pull it out.
• Place the hand from which you will be drawing blood straight on the table, palm facing up. Prick to the side of the fingertip (middle finger or ring finger) facing the little finger.
• Place the lancet through the hole on the side of your finger. Push the lancet down until you hear a "click", then feel the lancet penetrate the skin. After the "click" you can remove the lancet from your finger.
• wipe the first drop of blood with a clean tissue (not included). Put your arm down for about 10 seconds to stimulate blood flow.
• Hold your finger over the round hole in the restoration cassette and expel the blood from the finger you inserted with the lancet in step 5. Do this until a drop of blood forms. drop a drop of blood into the hole marked "SAMPLE". Do not smear the blood. Add blood until the entire white hole is covered.
• Add 6 drops of reagent from the vial included in the test kit to the "SAMPLE" hole on the test cartridge.
• Wipe off the rest of the blood from the finger with a tissue and seal the finger with the enclosed bandage.
• You can read the test result in 10 minutes, but no longer than in 15 minutes.

Results:

• Positive result: Two colored stripes (control and test) appear in the oval hole of the test cartridge. Your blood contains antibodies against the bacteria that cause syphilis. It is highly likely that you have been infected. Contact your GP immediately.
• Negative result: One colored strip (control) appeared in the oval hole of the test cartridge. This means that the test was performed correctly and that you are not infected with syphilis. However, it may also mean that the concentration of anti-bacterial antibodies in the blood sample was too low to show a positive result. if any symptoms persist, we recommend contacting your doctor.
• Invalid result: No streak appears in the oval hole of the test cartridge. This means that the test was not performed correctly.

Packing:

1 aluminum package with IMP Syphilis test cartridge, 1 lancet, 1 adhesive band, 1 reagent bottle, 1 instruction

Notice:

The test is for single use only. Store at room temperature 4-30 ° C and out of reach of children. Read the instructions for use carefully before performing the test.